Grouping & Remappers

This is not a bug, but a behaviour of the grouping algorithm that needs to be improved, IMHO:

1. Select a component that has a control with an active remapper on an incoming connection (use non-default values on the remapper to better observe the behaviour) and group it.

2. Apparently, all the properties of the original control are copied to the newly created control inside the group, including the 'Use remapping' state and the remapper's settings. This is good!

3. However, the control that remained outside the group now still has its 'Use remapping' state active, but uses default values for the remapper (i.e. it basically doesn't remap at all).

Here's the thing: If it doesn't remap, why have the 'Use remapping' state active? IMO the remapping algo should always transfer all existing remapping inside the group, and default to non-remapped exterior connections.

Sent both items to the programmers.